I wasn't sure where else to notify someone about this. If I create a work order which contributes to the downtime of an asset, the start and end time of the down time is rarely correct because we can't mark it on a computer while we're fixing it. As such we often have to go back and manually change the start/end time of down time on an asset in a work order. When I do that, it seems to track the correct amount of time, which is good, but visually it still shows the original date of when the downtime was marked started/ended. I doubt this is the intended functionality and it should instead show the real start/end time. See the attached image for example. The total amount of downtime on WO #2279 shows 4h17m which is correct, however, the start time is listed at 8:39AM and the end time is listed as 9:17AM. If this were the case then the total down time should be 0h38m. However the reason it shows 4h17m is because I manually changed the start time of the down time to be 5:00AM, which is really when the down time started. As such the 4h17m shown is correct, but the listed start time of 8:39AM is incorrect. I assume this is a bug and should instead show 5:00AM.